Print Page - MIDI Active Sensing message

Title: MIDI Active Sensing message
Post by: DjTony1981 on April 06, 2017, 10:03:18 AM

Hi to all.
I'm using my old arranger keyboard by connecting it to vArranger with a MIDI-USB interface in the IN port, and the SD1000 in the OUT port. The keyboard transmits MIDI "Active Sensing" messages causing an incorrect type sending MIDI NOTE ON / OFF message, pitch well and everything else. So i'm forced to use MIDI-OX to filter these messages and send them back to vArranger clean. It's can possible to filter them directly from vArranger? Can you add a general MIDI message filter on vArranger?
Thank you.

Title: Re: MIDI Active Sensing message
Post by: Dan on April 06, 2017, 10:12:15 AM

This has been corrected in the new SD1000 Firmware
http://www.ketron.it/en/software/176-sd1000/sd1000-1-4

Title: Re: MIDI Active Sensing message
Post by: DjTony1981 on April 06, 2017, 10:46:38 AM

It's possible implement a MIDI Filter in vArranger or would be too expensive?
Thanks.

Title: Re: MIDI Active Sensing message
Post by: Dan on April 06, 2017, 11:02:34 AM

What is your keyboard and what is your midi interface?
I think the Active Sensing is generated by your midi interface, and not by vArranger

Title: Re: MIDI Active Sensing message
Post by: DjTony1981 on April 06, 2017, 12:05:26 PM

In fact it is not a vArranger problem, MIDI messages are generated from my arranger keyboard. I also have a keyboard controller and does not generate these messages. I just wonder if it can be implemented, unhurried course.

I'm using a GEM WK2 and a GEM WX2.

Title: Re: MIDI Active Sensing message
Post by: Dan on April 06, 2017, 01:32:55 PM

vArranger already filter the Active sensing, and does not sent it back to the SD1000

Title: Re: MIDI Active Sensing message
Post by: DjTony1981 on April 07, 2017, 07:57:56 AM

Ok, perfect!
Thank you.

vArranger Forums

English => The vArranger² Software Forum => Topic started by: DjTony1981 on April 06, 2017, 10:03:18 AM