I was wrong. My MIDI IN 3 is set to UM-ONE
I have MIDI OUT 3 available.
Current setup for MIDI outs.
MIDI OUT 1 Motif Rack XS
MIDI OUT 2 vArranger Software Synthesizer
Thinking about adding VB3 as a VST for organ sounds.
But it brings to mind a scenario if you have 2 keyboards (MIDI IN 1 and MIDI IN 2), a nanocontrol (MIDI IN 3) and a midi foot controller (NO MIDI IN available), there are not enough MIDI IN's
Pedal Controller / Volume Control is a MIDI IN not a MIDI OUT
Still one free for the VST that can load 16 VST instruments
Thanks Dan, I revised my post.
I added this too.
But it brings to mind a scenario if you have 2 keyboards (MIDI IN 1 and MIDI IN 2), a nanocontrol (MIDI IN 3) and a midi foot controller (NO MIDI IN available), there are not enough MIDI IN's
Yes. Maybe you can plug the FCB1010 MIDI OUT to one keyboard MIDI IN, and maybe the keyboard can send back what it receives to is midi out
If not, I need to add a 4th MIDI IN
Thanks Dan. I will let you know when I get my setup complete.
I may be getting a Nektar LX 61 (for upper manual) which has a lot of controls on it and a Nektar iX61 (for lower manual).
Nektar iX61 and Nektar LX 61 haven`t conventional Midi In/Out Interface
and you can`t use them for Midi thru function with Behringer FCB1010. For
this setup with Nanocontrol you need nor one Midi In or you buy one Key
with Midi In/Out Interface !!!
Dan is it possible to add one Midi In and one Midi Out ? It can be very usefull
in big Setups with more Keys and Controllers and with more hardware synths.
I may get the Nektar LX88 and only need one keyboard then.