MIDI Active Sensing message

[DjTony1981]

Hi to all.
I'm using my old arranger keyboard by connecting it to vArranger with a MIDI-USB interface in the IN port, and the SD1000 in the OUT port. The keyboard transmits MIDI "Active Sensing" messages causing an incorrect type sending MIDI NOTE ON / OFF message, pitch well and everything else. So i'm forced to use MIDI-OX to filter these messages and send them back to vArranger clean. It's can possible to filter them directly from vArranger? Can you add a general MIDI message filter on vArranger?
Thank you.

[Dan]

This has been corrected in the new SD1000 Firmware
http://www.ketron.it/en/software/176-sd1000/sd1000-1-4

[DjTony1981]

It's possible implement a MIDI Filter in vArranger or would be too expensive?
Thanks.

[Dan]

What is your keyboard and what is your midi interface?
I think the Active Sensing is generated by your midi interface, and not by vArranger

[DjTony1981]

In fact it is not a vArranger problem, MIDI messages are generated from my arranger keyboard. I also have a keyboard controller and does not generate these messages. I just wonder if it can be implemented, unhurried course.

I'm using a GEM WK2 and a GEM WX2.

[Dan]

vArranger already filter the Active sensing, and does not sent it back to the SD1000

[DjTony1981]

Ok, perfect!
Thank you.